Designed for low speed roadways where pedestrians are present and to warn vehicular traffic they are entering an area requiring extra caution. With the 7 day timer system it can be activated at certain times of the day to emphasize its effectiveness.


The Solar School Zone Beacon only utilizes the most up to date solar and electronics to maintain power levels thru rain, shine, sleet, or snow


LED technology increases life expectancy of the solar beacon and also burns less energy than conventional bulbs


Meets MUTCD (Manual on Uniform Traffic Control Devices)


The system fits into Safe Routes to School (SRTS) infrastructure funding models


The 365 day Programmable timer module allows you to program in advance what days the solar beacons will be activated, not be activated, and time of day they are activated.


NCHRP 350 Crash Tested and Accepted (National Cooperative Highway Research Program)


Meets ITE Standards (Institute of Transportation Engineers)

Signal Head Housing

  • Maximum Power (P max) 20 W
  • Voltage at Pmax (V mp) 17.3 V
  • Current at Pmax (IMP) 1.16 A
  • Short-Circuit Current (Isc) 1.29 A
  • Open-Circuit Voltage (Voc) 21.6 V Solid State Regulator (In LED Housing)

Electrical Specifications

  • Voltage: 12V
  • Rated Solar Input: 10A
  • Rated Load Current: 10A
  • Equalization Voltage: 14.8V
  • Boost Battery: 14.4V
  • Float Battery: 13.6V
  • Low Voltage Disconnect: 11.1V
  • Low Voltage Reconnect: 13.1V
  • Self-Consumption: 6 mA
  • Operating Temp. -35 to +55ºC Traffic Hazard Beacons Polycarbonate Housing:
  • 12” light housing plastic injected molded polystyrene tufen u.v. impregnated material for ultra violet rays

Electrical Specifications

  • Led Color Yellow/Amber
  • Applied Voltage 12VDC
  • Power Consumption (watts) 5
  • Dominant Wavelength (nm) 592
  • On Axis Luminous Intensity (Min) 350 cd
  • LEDs per signal lamp 121
  • Intensity loss due to single LED failure .83%
  • Operation Temperature -40°F to +165°F Solid State Flasher (In LED Housing)
  • Input voltage of 12 VDC
  • Flash rate 60 F.P.M.
  • Input voltage of 12 VDC (2 terminals)
  • Two outputs of 12 VDC (4 terminals)
  • Capable of switching 5 amps @ 12 VDC
  • Input and output terminals 1/4 male quick connect
  • Epoxy encapsulated construction
  • Flasher is 3″ x 1½”, two outer mounting holes Battery (In Each LED Housing)
  • (2) 7.5 amp AGM Battery 7 Day Programmable Timer (In LED Housing)
  • 18 amp AGM Battery (Optional)
AC-OPT20 For Models: 108-D12; 120-S8; 120-D8; 122-S12; 122-D12; 126-D12; 128-D12; 130-D8; 132-D12. Remove 20W solar panel, solar panel mounting bracket, battery, large battery box and regulator. Add 20W power supply and small control cabinet.